Tables
12.1 List of statements
Fundamentals
12-6 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
DYNFINISH Dynamic for smooth-finishing DYNFINISH G1 X10
Y20 Z30 F1000
m 59
DYNNORM Standard dynamic, as previously DYNORM G1 X10 m 59
DYNPOS Dynamic for positioning mode, tapping DYNPOS G1 X10 Y20
Z30 F...
m 59
DYNROUGH Dynamic for roughing DYNROUGH G1 X10
Y20 Z30 F10000
m 59
DYNSEMIFIN Dynamic for finishing
Technology G
group
DYNSEMIFIN G1 X10
Y20 Z30 F2000
m 59
ENAT
1
Natural transition to next traversing block (end
natural)
m 20
ETAN Tangential transition to next traversing block at
spline end (end tangential)
m 20
F Feed value
(in conjunction with G4 the dwell
time is also programmed in F)
0.001, ...,
99999.99
9
Path feedrate
tool/workpiece;
unit of
measurement in
mm/min or
mm/rev
dependent on
G94 or G95
F=100 G1 ...
FA Axial feed (feed axial) 0.001, ...,
999999.9
99
mm/min,
degrees/
min;
0.001, ...,
39999.99
99
inch/min
FA[X]=100 m
FCUB
6
Feedrate variable according to cubic spline
(feed cubic)
Acts on feed
with G93 and
G94
m 37
FD Path feed for handwheel override
(feed DRF)
Real, w/o
signs
s
FDA Axial feed for handwheel override
(feed DRF axial)
Real, w/o
signs
s
FENDNORM Corner deceleration OFF m 57
FFWOF
1
Feedforward control OFF (feed forward OFF) m 24
FFWON Feedforward control ON (feed forward ON) m 24
FGREF Reference radius of rotary axis or path
reference factors of orientation axes (vector
interpolation)
Reference size
effective value
m
FGROUP Definition of axis/axes with path
feed
F applies to all
axes
programmed
under FGROUP
FGROUP (axis1,
[axis2], ...)
To Next Page
Loading...
