Siemens SINUMERIK 810DE - Page 442

Tables
12.3 List of G functions/preparatory functions
Fundamentals
12-36 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Group 22: Tool offset types
Name No. Meaning X m/n SAG MM
CUT2D 1. Cutter compensation type 2-dimensional 2 1/2D tool offset determined by
G17 – G19
m Def.
CUT2DF 2. Cutter compensation type 2-dimensional frame – relative: 2 1/2D tool
offset determined by frame
The tool offset is effective in relation to the current frame
(inclined plane)
m
CUT3DC # 3. Cutter compensation type 3-dimensional circumference: 3D tool
compensation circumference milling
m
CUT3DF # 4. Cutter compensation type 3-dimensional face: 3D tool offset with
inconstant tool orientation
m
CUT3DFS # 5. Cutter compensation type 3-dimensional face: 3D tool offset face milling
with constant tool orientation independent of active frame
m
CUT3DFF # 6. Cutter compensation type 3-dimensional face frame: 3D tool offset face
milling with constant tool orientation dependent on active frame
m
CUT3DCC # 7. Cutter compensation type 3-dimensional circumference: 3D tool offset
circumferential milling with limitation surfaces
m
CUT3DCCD # 8. Cutter compensation type 3-dimensional circumference: 3D tool offset
circumferential milling with limitation surfaces with differential tool
m
# The vocabulary word is not valid for SINUMERIK 810D/NCU571.
Group 23: Collision monitoring at inside contours
Name No. Meaning X m/n SAG MM
CDOF 1. Collision detection OFF: Collision monitoring OFF m Def.
CDON 2. Collision detection ON: Collision monitoring ON m
CDOF2 3. Collision detection OFF: Collision monitoring OFF
(currently only for CUT3DC)
m
Group 24: Feedforward control
Name No. Meaning X m/n SAG MM
FFWOF 1. Feed forward OFF: Feedforward control OFF m Def.
FFWON 2. Feed forward OFF: Feed forward control ON m
Group 25: Tool orientation reference
Name No. Meaning X m/n SAG MM
ORIWKS # 1. Tool orientation in workpiece coordinate system: Tool orientation in
workpiece coordinate system (WCS)
m Def.
ORIMKS # 2. Tool orientation in machine coordinate system: Tool orientation in
machine coordinate system (MCS)
m
# The vocabulary word is not valid for SINUMERIK 810D/NCU571.