04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–98
SINUMERIK 840C / SIMODRIVE 611–D (DA)
101002 NCK software not available on hard disk
–
NCK is not powering-up: MMC powers up without NCK
S Required data for loading not available in defined directory
S Install NCK software on MMC
101002 NCK user data being loaded
When user data are being loaded.
None
Data in user/NC/data directory being loaded
Alarm in SW 5 and higher
101003 Checksum error when booting the NCK
–
NCK is not powering-up: MMC powers up without NCK
S Faulty loaded file (wrong checksum or wrong format)
S POWER ON
S Re-install NC software, if necessary
Applies for SW 2 only
101003 User file not loaded
At system start
File in the user/NC/data directory is not loaded.
No file operation (read, position, ...) could be performed on the user file ... or an error occurred during transfer. In
the case of file operations, message 105011 is not issued (a reference to the faulty file operation).
Correct the data in the user/NC/data directory.
Alarm in SW 5 and higher
101003 Error in NCK/user/data load
At system start
Data in the directory user/NC/data are not loaded into the NCK
–
Correct data in the directory user/NC/data. Only GIA data (file name GIA) and IKA data (file names IKA1, IKA2,
IKA3) should be stored there.
Applies from SW 3 to SW 4.4
101004 MMC–NC data link not ready (log)
–
NCK is not powering-up: MMC powers up without NCK
S Software error in transport protocol
S Faulty loaded file
S POWER ON
S Replace hardware, reinstall software
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
