Siemens SINUMERIK 840C - Page 109

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–101
SINUMERIK 840C / SIMODRIVE 611–D (DA)
104005 Caution File has lines which are too long OK softkey
When reading in file
Line wrapround with LF
Line length > 128 characters (as from SW 4: > 256 characters)
–
Applies up to SW 4.5
104005 File or harddisk failure OK softkey
in ASCII editor
Operation aborted.
An error has occurred in the editor during a write/read operation on the hard disk.
Perform chkdisk;
replace MMC
Aplies as from SW 5
104006 The hard disk is full OK softkey
When expanding the current file in ASCII editor
Operation is aborted
The ASCII editor cannot generate any further internal auxiliary files
Reduce number of files on the hard disk.
Applies up to SW 4.4
104006 File cannot be processed further OK oftkey
ASCII editor
Possible causes are
1. File is  8 MB
2. File  8 MB was processed further
3. Hard disk is full
4. Hard disk error
S for 1, 3, 4: exit file without saving
S for 2: changes made up to this message can be saved.
Applies as from SW 4.4
104007 Line wrapround due to excessively long lines OK softkey
When reading in file
–
Line length > 128 characters (as from SW 4: > 256 characters)
–
104008 Save not possible at present time OK softkey
When saving file
File is not saved
File is still open somewhere else (e.g. execution from harddisk)
Wait until execution has ended
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Note
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description