Siemens SINUMERIK 840C - Page 153

04/96

Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–145
SINUMERIK 840C / SIMODRIVE 611–D (DA)
146709 ”Block with @711: too much info. in block”
146730 ”Axis not allowed here –> ignored”
146731 ”IPO parameters not allowed here –> ignored”
146732 ”Radii not allowed here –> ignored”
146733 ”Angle not allowed here –> ignored”
146734 ”F word not allowed here –> ignored”
146735 ”M words not allowed here –> ignored”
146736 ”S word not allowed here –> ignored”
146737 ”T word not allowed here –> ignored”
146738 ”H word not allowed here –> ignored”
146739 ”D word is not allowed here –> ignored”
146740 ”Comments not allowed here”
146741 ”:–word not allowed here –> ignored”
146742 ”Only @714 allowed here. Other @ ignored”
146743 ”@706/@715/@720 not allowed here –> ignored”
146744 ”Progr. coord. [...] illegal here –> ignored”
146745 ”L word not allowed here –> ignored”
146746 ”N word not allowed here –> ignored”
146747 ”P word not allowed here –> ignored”
160001 Axis already assigned OK softkey
On “START”
The selected function is not started
No further startup functions can be started with the defined axis number
Terminate the startup function already active for this axis
160002 Axis not configured or configured wrongly OK softkey
Startup application
Startup function is not executed
Selected axis is not available
Select available axis
160003 Drive module is not configured or incorrectly OK softkey
Startup application
Startup function is not executed
Selected drive number is not available
Select available drive module
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description