04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–153
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160059 Measurement function already active OK softkey
When starting measuring function
Start command is ignored if measuring function is already running.
–
–
160060 Measurement in progress OK softkey
Startup applications measuring functions
–
Operational message during measuring function
–
160061 PI function code ... , error 0x ... OK softkey
Startup application
Function aborted
Error on internal consistency check
End application and restart
160062 Package sequence error OK softkey
Startup application
Function aborted
Error on internal consistency check
End application and restart
160063 Press “Accept configuration” softkey OK softkey
Startup application
Application operating with inconsistent data
Drive configuration must be updated after NCK reset or 611D ramp-up
Press “OK” and “Accept configuration” softkeys
160064 Log error OK softkey
611D communication
Function aborted
Error on internal consistency check
Start up control/drive; deselect faulty module
160065 System error start-up application OK softkey
Startup application
Undefined
Startup application is no longer stable
MMC reset
160066 Temporarily no access rights OK softkey
Startup application
Startup function is not executed
Application has no access rights for required data
Enter password/alter keyswitch position
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
