04/96
Siemens AG 2001 All rights reserved 6FC5198–jAB40
1–155
SINUMERIK 840C / SIMODRIVE 611–D (DA)
160075 Illegal measuring time OK softkey
Measuring function parameterization
The function cannot be started
The defined measuring time is too great
Enter a smaller value not equal to zero
160076 Illegal operating mode OK softkey
Function generator/measuring function parameterization
The function cannot be started
Stated mode cannot be executed (check by servo/611D)
Possible causes:
S Start-up function of an axis in spindle operation
S Start-up function of a spindle in C axis operation
S Travel against fixed stop is active
S The axis/spindle is a GI following axis/spindle
S The axis/spindle is a slave axis/spindle
S Start-up function of a spindle without encoder (MD 520*, bit 2)
Enter a different operating mode
160077 Illegal offset OK softkey
Function generator/measuring function parameterization
The function cannot be started
Stated value too high
Enter a smaller value
160078 Illegal settling time OK softkey
Measuring function parameterization
The function cannot be started
Stated value too high
Enter smaller value
160079 Illegal pulse width OK softkey
Function generator parameterization
Function cannot be started
–
Enter sensible value
160080 Illegal ramp duration OK softkey
Measuring function parameterization
Function cannot be started
–
Enter smaller value
160081 Illegal traversing range limits OK softkey
Function generator/measuring function parameterization
The function cannot be started
–
Enter lower value; “0” means no monitoring
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
Scan
Effect
Explanation
Remedy
1 Alarms
1.5.1 Alarm description
To Next Page
Loading...
