Siemens SINUMERIK 840D - Page 561

NCK alarms
11/2006 Overview of Alarms
2-561
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61703 Channel %1 block %2: Internal cycle error while deleting file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61704 Channel %1 block %2: Internal cycle error while writing to file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61705 Channel %1 block %2: Internal cycle error while reading to file
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61706 Channel %1 block %2: Internal cycle error while generating checksum
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61707 Channel %1 block %2: internal cycle error with ACTIVATE at HMI
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61708 Channel %1 block %2: internal cycle error with READYPROG at HMI
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE950, CYCLE73, CYCLE74, CYCLE75.
Remedy: --
61709 Channel %1 block %2: Timeout in contour calculation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --