Siemens SINUMERIK 840D - Page 564

Overview of Alarms 11/2006
NCK alarms
2-564
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61729 Channel %1 block %2: Internal error: Memory space problem
_ALLOC_P_EXTERNAL_ERROR
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61730 Channel %1 block %2: Internal error: invalid memory
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61731 Channel %1 block %2: Internal error: floating point exception
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61732 Channel %1 block %2: Internal error: invalid instruction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61733 Channel %1 block %2: Internal error: Floating_Point_Error
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61734 Channel %1 block %2: Cutting edge not compatible with cutting direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61735 Channel %1 block %2: Finished part not within blank contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: Check blank contour definition.