Siemens SINUMERIK 840D - Page 565

NCK alarms
11/2006 Overview of Alarms
2-565
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61736 Channel %1 block %2: Insert length of tool < machining depth
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61737 Channel %1 block %2: Machining_cutting_depth > tool nose radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61738 Channel %1 block %2: Machining_cutting_depth < tool nose radius
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61739 Channel %1 block %2: Wrong insert position of tool for this machining
operation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61740 Channel %1 block %2: Blank must be closed contour
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: Check whether blank contour is closed, i.e. starting point = end point.
61741 Channel %1 block %2: Abort due to insufficient memory space
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --
61742 Channel %1 block %2: Approach collision, correction not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE950.
Remedy: --