Siemens SINUMERIK 840D - Page 567

NCK alarms
11/2006 Overview of Alarms
2-567
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
61801 Channel %1 block %2: Wrong G code selected
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the program call CYCLE300<value> an impermissible numerical value was programmed for the
entered CNC System, or in the Cycles Setting Datum an incorrect value for the G Code System was
set.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Internal
61802 Channel %1 block %2: Wrong axis type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed axis is assigned to a spindle
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Internal
61803 Channel %1 block %2: Programmed axis not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed axis is not in the system.
Alarm triggered by following cycles: CYCLE83, CYCLE84, CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check parameter _AXN.
Check MD20050-20080.
Program
Continuation:
Clear alarm with the RESET key. Restart part program
61804 Channel %1 block %2: Progr. position exceeds reference point
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed intermediate position or actual position is behind the reference point.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: --
Program
Continuation:
Internal