Siemens SINUMERIK 840D - Page 655

HMI alarms
11/2006 Overview of Alarms
2-655
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
107054 MCU: Traversing program not available !
Definitions: --
Remedy: --
107055 MCU: Active program cannot be changed !
Definitions: --
Remedy: --
107058 MCU: Transfer of traversing program terminated without errors!
Definitions: --
Remedy: --
107059 MCU: Transfer of traversing program aborted !
Definitions: --
Remedy: --
107061 MCU: Program number exists already!
Definitions: --
Remedy: --
107062 MCU: Program number not permissible (1 ... 199) !
Definitions: --
Remedy: --
107063 MCU: Block number not permissible %1 !
Parameters: %1 = --
Definitions: --
Remedy: --
107064 MCU: G function not allowed !
Definitions: --
Remedy: --
107065 MCU: Tool offset number (D.) not permissible (0 ... 20) !
Definitions: --
Remedy: --
107066 MCU: During a dwell time, only M functions are permissible !
Definitions: --
Remedy: --
107067 MCU: Insertion of a block not possible !
Definitions: --
Remedy: --
107068 MCU: Subroutine call allowed only with quantity !
Definitions: --
Remedy: --