Siemens SINUMERIK 840D - Page 656

Overview of Alarms 11/2006
HMI alarms
2-656
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
107069 MCU: Appending a block not possible !
Definitions: --
Remedy: --
107080 MCU: Unknown error at %1
Parameters: %1 = --
Definitions: --
Remedy: --
107081 MCU: Command being processed (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107082 MCU: Command number unknown (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107083 MCU: Acknowledgment op code wrong (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107084 MCU: Drive not digital (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107085 MCU: Servo number unknown (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107086 MCU: Wait for stop acknowledgment (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107087 MCU: Unknown management status (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --
107088 MCU: Not allowed in this PLC mode (%1) !
Parameters: %1 = --
Definitions: --
Remedy: --