Tables
12.1 List of statements
Fundamentals
12-8 Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
G0 Linear interpolation with rapid traverse (rap. traverse
motion)
G0 X... Z... m 1
G1
1
Linear interpolation with feedrate (linear interpolation) G1 X... Z... F... m 1
G2 Circular interpolation clockwise G2 X... Z... I... K... F...
;Center point and end
point
G2 X... Z... CR=... F...
;radius and end point
G2 AR=... I... K... F...
;aperture angle and
;center point
G2 AR=... X... Z... F.
;aperture angle and
;end point
m 1
G3 Circular interpolation counter-clockwise
Motion
commands
G3 ...; otherwise as for
G2
m 1
G4 Dwell time preset Special
motion
G4 F... ; Dwell time in
seconds or
G4 S... ;Dwell time in
;spindle revolution
;separate block
s 2
G5 Oblique plunge-cut grinding Oblique
plunge-
cutting
s 2
G7 Compensatory motion during oblique plunge-cut grinding Start posit. s 2
G9 Exact stop - deceleration s 11
G17
1
Selection of working plane X/Y Infeed dir. Z m 6
G18 Selection of working plane Z/X Infeed dir. Y m 6
G19 Selection of working plane Y/Z Infeed dir. X m 6
G25 Lower working area limitation G25 X.. Y.. Z..
;separate block
s 3
G26 Upper working area limitation
Value
assignment
in channel
axes
G26 X.. Y.. Z..
;separate block
s 3
G33 Thread interpolation with constant pitch 0.001, ...,
2000.00
mm/rev
Motion
command
G33 Z... K... SF=...
;cylindrical thread
G33 X... I... SF=...
;face thread
G33 Z... X... K... SF=...
;taper thread
;(bigger in Z-axis path
;than in X-axis)
;G33 Z... X... I... SF=...
;taper thread
;(bigger in X-axis path
;than in Z-axis)
m 1
G34 Linear degressive speed change [mm/rev
2
] Motion
command
G34 X.. Y.. Z.. I.. J.. K..
F..
m 1
G35 Linear progressive speed change [mm/rev
2
] Motion
command
G35 X.. Y.. Z.. I.. J.. K..
F..
m 1
G40
1
Tool radius compensation OFF m 7
G41 Tool radius compensation left of contour m 7
To Next Page
Loading...
