Tables
12.1 List of statements
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-9
G42 Tool radius compensation right of contour m 7
G53 Suppression of current zero offset (non-modal) including
programme
d offsets
s 9
G54 1st settable zero offset m 8
G55 2. Settable zero offset m 8
G56 3. Settable zero offset m 8
G57 4. Settable zero offset m 8
G58 Axial programmable zero offset, absolute s 3
G59 Axial programmable zero offset, additive s 3
G60
1
Exact stop - deceleration m 10
G62 Corner deceleration at inside corners when tool radius
offset is active (G41, G42)
Together
with
continuous-
path mode
only
G62 Z... G1 m 57
G63 Tapping with compensating chuck G63 Z... G1 s 2
G64 Exact stop - continuous-path mode m 10
G70 Dimension in inches (lengths) m 13
G71
1
Metric dimension (lengths) m 13
G74 Reference point approach G74 X... Z...
;separate block
s 2
G75 Fixed point approach Machine
axes
G75 FP=.. X1=... Z1=...
;separate block
s 2
G90
1
Absolute dimensions G90 X... Y... Z...(...)
Y=AC(...) or
X=AC Z=AC(...)
m
n
14
G91 Incremental dimension input G91 X... Y... Z... or
X=IC(...) Y=IC(...)
Z=IC(...)
m
n
14
G93 Inverse-time feedrate 1/rpm Execution of
a block:
Time
G93 G01 X... F... m 15
G94
1
Linear feedrate F in mm/min or inch/min and °/min m 15
G95 Revolutional feedrate F in mm/rev or inches/rev m 15
G96 Constant cutting speed (as for G95) ON G96 S... LIMS=... F... m 15
G97 Constant cutting speed (as for G95) OFF m 15
G110 Pole programming relative to the last programmed setpoint
position
G110 X.. Y.. Z.. s 3
G111 Polar programming relative to origin of current workpiece
coordinate system
G110 X.. Y.. Z.. s 3
G112 Pole programming relative to the last valid pole G110 X.. Y.. Z.. s 3
G140
1
SAR approach direction defined by G41/G42 m 43
G141 SAR approach direction to left of contour m 43
G142 SAR approach direction to right of contour m 43
G143 SAR approach direction tangent-dependent m 43
G147 Soft approach with straight line s 2
To Next Page
Loading...
