Tables
12.3 List of G functions/preparatory functions
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
12-37
Group 26: Repositioning point for REPOS
Name No. Meaning X m/n SAG MM
RMB 1. REPOS mode beginning of block: Reapproach to start of block position m
RMI 2. REPOS – Mode interrupt: Reapproach to interruption point m Def.
RME 3. REPOS mode end of block: Repositioning to end-of-block position m
RMN 4. REPOS mode end of nearest orbital block: Reapproach to nearest path
point
m
Group 27: Tool offset for change in orientation at outside corners
Name No. Meaning X m/n SAG MM
ORIC # 1. Orientation change continuously: Orientation changes at outside corners
are superimposed on the circle block to be inserted
m Def.
ORID # 2. Orientation change discontinuously: Orientation changes are performed
before the circle block
m
# The vocabulary word is not valid for SINUMERIK 810D/NCU571.
Group 28: Working area limitation ON/OFF
Name No. Meaning X m/n SAG MM
WALIMON 1. Working area limitation ON: Working area limitation ON m Def.
WALIMOF 2. Working area limitation OFF: Working area limitation OFF m
Group 29: Radius - diameter
Name No. Meaning X m/n SAG MM
DIAMOF 1. Diametral programming OFF: Diameter programming OFF; radius
programming for G90/G91
m Def.
DIAMON 2. Diametral programming ON: Diameter programming ON for G90/G91 m
DIAM90 3. Diametral programming G90: Diameter programming for G90; radius
programming for G91
m
DIAMCYCOF 4. Diametral programming OFF: Radius programming for G90/G91: ON.
The G-code of this group that was last active remains active for display
m
Group 30: Compressor ON/OFF
Name No. Meaning X m/n SAG MM
COMPOF # 1. Compressor OFF m Def.
COMPON # 2. Compressor ON m
COMPCURV
#
3. Compressor ON: Polynomials with constant curvature m
COMPCAD # 4. Compressor ON: Optimized surface quality CAD program m
To Next Page
Loading...
