Siemens Sinumerik 840DiE sl - Page 118

01/2007
5.4 Service Desktop
5-118
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
S HMI Explorer
The HMI Explorer is used to display the version and install or post --install the
supplied SINUMERIK application. See Section 5.4.7, Page 5-121.
S Touchware
Program for calibrating the touchscreen connected to the PCU directly.
References
/BHsl/ Operator Components Manual
Section: Configure system
Configure system network with ’Settings system network’
S Settings System Network
Setting up the Ethernet connection of a TCU to the SINUMERIK 840Di sl.
References
/IAM2/ CNC Commissioning Part 5
Section: Thin Client Configuration (IM5)
Commissioning
Calibration of the touchscreen
S HMI Analyzer
Analysis tool for HMI Advanced in conjunction with PCU 50.3
References
/IAM/ CNC Commissioning Part 2
Section: Commissioning HMI Advanced IM4
Diagnosis and Service
HMI Analyzer
S ServiceCenter
Starts the ServiceCenter after the computer reboots under WinPE to create,
restore and manage partition and hard disk images.
References
/IAM2/ CNC Commissioning HMI Advanced
Section: IM8 PCU--Basesoftware 8.x
Save and restore data
S Folder: SINUMERIK 840Di
-- SINUMERIK 840Di Start--up
Simple SINUMERIK 840Di--specific user interface.
-- NT desktop/HMI desktop
Autostart of the HMI application:
OFF/ON
See Section 5.4.3, Page 5-119.
-- Readme
Notes and conditions concerning the installed SINUMERIK 840Di sl
system software.
5Powe
r
On
a
n
d
Powe
r
--
U
p