01/2007
5.5 ServiceCenter
5-123
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
5.5 ServiceCenter
The ServiceCenter is used to create, restore and manage partition and hard
disk images. With the SINUMERIK 840Di sl, the startup mode of NCK and PLC
can also be specified via the ServiceCenter.
The ServiceCenter is intended for the machine manufacturer/service personnel.
5.5.1 Activation
Proceed as follows to enable the Service Desktop:
1. Restart the PCU, e.g. via Power Off/On.
2. While starting up the PCU, press the ”#” key (cursor down) in the selection
screen for the operating system to be started. (The selection screen is dis-
played immediately after the booting of the PCU.)
OS Loader ...
Please select the operating system to start:
SINUMERIK
Service Desktop (not visible)
Use " and # to highlight your choice.
Press Enter to choose.
3. Enter a password for protection levels 0 – 2:
Protection
level
Password Area
0 Reserved Siemens
1 SUNRISE (default) Manufacturer
2 EVENING (default) Commissioning, service
4. Press the Enter key for immediate activation of the selection or wait until the
selection is started automatically after the preset wait time has elapsed.
5.5.2 Setting NCK/PLC startup mode
In the SINUMERIK 840Di sl–specific part of the ServiceCenter, you can specify
the mode that the NCK and PLC are to assume after start–up. The following
options can be set:
S Start NCK and PLC
S Do not start NCK and PLC
S Start NCK and PLC in specified mode:
5 Power On and Power–U
To Next Page
Loading...
