Siemens Sinumerik 840DiE sl - Page 14

01/2007
xiv
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
6.6.1 Requirements 6-154...............................................
6.6.2 Loading the configuration 6-154.....................................
6.6.3 Series startup file 6-155............................................
6.7 Testing the PLC program 6-156.....................................
6.7.1 Start--up behavior 6-156............................................
6.7.2 Cyclic operation 6-157.............................................
6.7.3 Monitor/control using the SIMATIC Manager 6-157.....................
6.7.4 Monitor/control using HMI Advanced 6-158...........................
6.8 Load configuration into PG (PLC --> STEP 7) 6-160....................
7 Ethernet Communication 7-161.............................................
7.1 General 7-161....................................................
7.1.1 Ethernet PCU connections 50.3 7-161................................
7.1.2 Determining the PCU Ethernet communication parameters 7-161........
7.1.3 Checking an Ethernet connection 7-162..............................
7.2 SINUMERIK 840Di sl commissioning tool: SinuCom NC 7-163..........
7.3 SINAMICS drive commissioning tool: STARTER 7-163.................
7.4 External HMI Advanced 7-164......................................
7.5 MCP 483C IE 7-165...............................................
7.5.1 Conditions for general commissioning 7-165..........................
7.5.2 Parameterization of the MCP 7-166..................................
7.5.3 MCP functions 7-168..............................................
7.5.4 Linking to the basic PLC and user program 7-169......................
7.5.5 Input/output image 7-171...........................................
8 PROFIBUS DP Communication 8-175.......................................
8.1 General 8-175....................................................
8.1.1 PROFIBUS DP interfaces of the MCI board 8-175.....................
8.1.2 PROFIBUS DP with Motion Control option 8-175......................
8.1.3 Message format for cyclic DP communication 8-176....................
8.1.4 Description of a DP cycle 8-177.....................................
8.1.5 Networking rules 8-178.............................................
8.2 Requirements 8-180...............................................
8.3 Creating a PROFIBUS configuration 8-183............................
8.3.1 Requirements 8-183...............................................
8.3.2 Inserting DP slaves 8-184..........................................
8.3.3 Final parameterization of the isochronous DP slaves 8-185.............
8.3.4 Generating system data blocks (SDB) 8-190..........................
8.3.5 Loading a configuration into the PLC 8-191...........................
8.3.6 PROFIBUS diagnosis 8-191........................................
8.4 SIMATIC I/O devices (ET200...) 8-192...............................
8.5 DP slave: I/O Module PP72/48 8-192................................
8.5.1 GSD file 8-192....................................................
8.5.2 Inserting a DP slave 8-193..........................................
8.5.3 Setting PROFIBUS parameters 8-193................................
8.5.4 Setting the I/O addresses 8-194.....................................
8.6 DP slave: MCP 310 8-195..........................................
8.6.1 General conditions for commissioning 8-195..........................
SI
N
U
M
E
RIK
8
40D
i
s
lM
a
nu
a
l
Con
t
en
t
s