Siemens Sinumerik 840DiE sl - Page 149

01/2007
6.3 Creating a SIMATIC S7 project
6-149
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
5. The configured Ethernet interface must be assigned to an interface parame-
terization of the PG/PC. Select the tab: ”Assignment” (1).
Select from the list: ”Configured interfaces”, the interface configured above:
”Ethernet (1)” (2) and from the list: ”Interface parameterizations in the
PG/PC”, the Ethernet interface via which the connection to the PCU is es-
tablished. In the example: ”TCP/IP –> Realtek RTL8139...” (3).
Notice
From the list: ”Interface parameterizations in the PG/PC”, do not select ISO
interfaces as Ethernet interfaces, e.g. ”ISO Ind. Ethernet –> Realtek
RTL8139...”. Instead, use the appropriate TCP/IP interfaces, e.g. ”TCP/IP –>
Realtek RTL8139...”.
Assign the interface using the ”Assign” button (4).
Confirm the next dialog: ”Edit Object Properties” with OK.
Properties – PG/PC
TCP/IP –> NdisWanlp
TCP/IP –> Realtek RTL8139/810x F...
TCP/IP(Auto) –> Intel(R) PRO/Wireless...
TCP/IP(Auto) –> Realtek RTL8139/81...
Not assigned
2
Assigning
OK
S7Online
Cancel
Interface parameterization in PG/PC:
Assigned:
Configured interfaces:
active
Help
S7ONLINE access:
General
1
Name
AssignmentInterface
SubnetType
Ethernet Interface(1) Industrial Ethernet Ethernet(1)
Interface SubnetParameterization
Remo
ve
3
4
The list ”Assigned” now contains the Ethernet interface (1). If several inter-
faces are assigned, make sure that the interface to be used for communica-
tion, ”Ethernet (1)” in this case, is active. To do this, select the interface
(Ethernet (1)) and activate the S7 online access for this interface (2). Click
OK to confirm the dialog.
6 PLC Commissionin
g