01/2007
7.5 MCP 483C IE
7-166
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
To commission the MCP the automation system must be completely electrically
and mechanically connected with respect to NC, PLC and MCP.
The drives must be secured against accidental moving.
7.5.2 Parameterization of the MCP
Fig. 7-4 shows the interfaces on the rear of the module:
Rotary switch
X30/X31
Ethernet connection
Handwheel signal type S1
X60/X61
Handwheel connection
DIP switch S2
LEDs 1...4
Ground terminal
Power supply X10
Ethernet 2 X21
Ethernet 1 X20
Emergency stop
Slots for
additional components
Customer–spec.
inputs/outputs
Fig. 7-4 Position of interfaces on rear side of machine control panel
For a detailed description of the electrical and mechanical design and of the
machine control panel interfaces, please refer to:
References: /BHsl/ Operator Components Manual
Section: Machine control panel MCP 483C IE
After the MCP has been electrically connected, all LEDs on the front side of the
MCP flash until communication is established between MCP and PLC.
Simultaneously pressing the two keys ”Feed stop” and ”Feed enable” displays
the version number of the current software using the LEDs now continuously
illuminated.
Example: Software version: V 01.02.00
1st digit
1)
2nd digit
1)
3rd digit
1)
Simultaneous pressing of the keys
”Feed enable” and ”Feed stop”
1 2 0
1) Display of the digit by means of continuously illuminated LEDs on the individual LED
blocks according to Fig. 7-5
Automation
system
Interfaces
Display of the
software version
7 Ethernet Communication
To Next Page
Loading...
