Siemens Sinumerik 840DiE sl - Creating a PROFIBUS Configuration

01/2007
8.3 Creating a PROFIBUS configuration
8-183
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
8.3 Creating a PROFIBUS configuration
8.3.1 Requirements
The procedure described in this section for setting up the PROFIBUS configura-
tion as well as the parameterization of various components (for example, SI-
NAMIC drives, AD14), is based on an S7 project created using the description
in Section 8.3, Page 8-183.
The following status of the S7 project is required:
– S7 project is has been set up (name: SIN840Di sl)
– Station 300 has been set up
– Interface (X102) MPI or PROFIBUS is parameterized
– Interface (X101) PROFIBUS is parameterized
– Input/output data areas of the NC are parameterized
Note
The instructions given in this section are essentially limited to the special
characteristics of the SINUMERIK 840Di sl. For more details about working with
SIMATIC STEP 7 please refer to the relevant SIMATIC documentation or online
help.
Start ”HW Config” by opening the station and double–clicking the hardware icon.
SIN840Di sl – <Installation path>\step7\s7proj\SIN840Di sl
SIN840Di sl Hardware
SIMATIC
300(1)
PLC 317–2DP 2AJ10
PLC 317–2DP 2AJ10
Fig. 8-4 Inserting the SIMATIC 300 station
In HW Config, now insert the required PROFIBUS modules from the hardware
catalog into the S7 project.
(10)
SINAM
HW Config – [SIMATIC 300(1) (Configuration) –– SIN840Di sl]
Station Edit Insert Target System View Tools Window Help
PROFIBUS(1): DP master system(1)
(0) 840Di sl
2 PLC 317–2DP 2AJ10
X1 MPI/DP
X2 DP
4 NCK 840D sl
5 CP 840D sl
SINAMICS
SINAMICSCX32
SINAMICS G130
SINAMICS G150
SINAMICS GM150
SINAMICS NX10
SINAMICS NX15
SINAMICS S150
Profile:
Find
Default
SINAMICS S120
Fig. 8-5 HW Config: Inserting modules, e.g. SINAMICS S120
S7 project
Starting HW
Config
8 PROFIBUS DP Communication