01/2007
8.6 DP slave: MCP 310
8-196
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
The following manuals are required for the commissioning of the MCP:
/FB1/ Description of Functions, Basic Functions
P3, PLC Basic Program
Program structure and modules of the PLC basic program.
/FB2/ Description of Functions, Extended Functions
H1 Jog with/without Handwheel
Commissioning of handwheels
/BH/ Operator Components Manual
Description of MCP 310 (interfaces, electrical connection, etc.)
/Z/ Catalog NCZ
Connection Components: Cables, connectors, etc.
To commission the MCP the automation system must be completely electrically
and mechanically connected with respect to NC, PLC and MCP.
The drives must be secured against accidental moving.
8.6.2 Parameterization of the MCP
Fig. 8-11 below shows the interfaces on the rear of the module:
COM board
COM board
Rotary switch X30/X31
Keyswitch X50
Power supply X10
PROFIBUS X20
Handwheels X60/X61
Direct keys X70
Handwheel signal type S1
Customer-spec. operating elements X51 ...X54
S3 DIP switch
LEDs 1...4
Termination:
Equipotential bonding
conductor
Fig. 8-11 Rear of the MCP 310 showing the control and display elements and the interfaces
References
Automation
system
Interfaces
8 PROFIBUS DP Communication
To Next Page
Loading...
