Siemens Sinumerik 840DiE sl - Page 215

01/2007
8.7 DP slave: MCP 483
8-215
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
Notice
The PROFIBUS address set in the S7 project for DP slave: MCP 483 must
match the PROFIBUS address set on the module (DIP switch S3).
There is no automatic adjustment!
The following data must agree:
1. SIMATIC configuration DP slave: MCP 483
PROFIBUS address
2. Machine control panel MCP 483
PROFIBUS address (DIP switch S3)
The active functions and hence the number of user data elements to be
transferred are chosen by selecting the appropriate pre--configured module.
The modules are listed in the hardware catalog under DP slave: MCP 483.
The following modules are available:
S Universal module (not applicable)
S standard
S standard, handwheel
S standard, extended
S standard, handwheel, extended
Module: standard
The module transfers the data for the ”Standard” function:
S Input data: 8 byte
Standard data
(8 bytes)
S Output data: 8 byte
Standard data
(8 bytes)
Module: standard, handwheel
The module transfers the data for the ”Standard” and ”Handwheel” functions:
S Input data: 12 bytes
Standard data
(8 bytes)
Absolute value
1st handwheel
(2 bytes)
Low byte
High byte
Absolute value
2nd handwheel
(2 bytes)
S Output data: 8 byte
Standard data
(8 bytes)
Adding a module
8
PROFIB
U
SDPCommun
i
c
a
t
i
on