Siemens Sinumerik 840DiE sl - System Components

01/2007
1.1 Overview of SINUMERIK 840Di sl
1-22
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
1.1.1 System components
This manual refers to the following system components:
System components Version
SINUMERIK 840Di sl system software SW 1.4
SINUMERIK Industrial PC
PCU 50.3–C: 1.5 GHz, 512 MB DRAM
PCU 50.3–P: 2.0 GHz, 1024 MB DRAM
PC operating system Windows XP ProEmbSys
MCI board MCI2 board for 840Di sl
Notice
It is not possible to combine the named system components with older
versions.
1.1.2 System software packages and quantity frameworks
The following system software packages are available for SINUMERIK 840Di sl:
S 6 axes system software
S 20 axes system software
The system software packages are each designed for the following quantities:
6 axes 20 axes
Basic
configuration
Maximum Basic
configuration
Maximum
Axes 3 6 5 20
Channels 1 2 1 10
Mode groups 1 2 1 10
Channels per
mode group
1 2 1
10
Basic configuration: Default number of available components
Maximum: Maximum possible number of components with additional options
1.1.3 Hardware components
The hardware basis for the SINUMERIK 840Di sl is an industrial PC further
referred to as PCU (PC–Unit) from Siemens A&D, in conjunction with the
MCI board (M
otion Control–Interface).
The SINUMERIK 840Di sl is available with the following PCU 50.3 versions,
each with 24 V power supply:
S PCU 50.3–C: 1.5 GHz, 512 MB SDRAM
S PCU 50.3–P: 2.0 GHz, 1024 MB SDRAM
System software
packages
Quantity
framework
PCU
1 General Information on the SINUMERIK 840Di sl