Siemens Sinumerik 840DiE sl - Creating a New Project

01/2007
9.2 ONLINE commissioning
9-244
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
9.2.1 Creating a new project
Perform the following actions to create a new project:
1. Start the STARTER drive commissioning tool using the icon on the user in-
terface or the Windows taskbar: Start > SIMATIC > STEP 7 > STARTER).
If the Project Wizard for creating a new project is not opened automatically
when initiating the STARTER, open it using menu command: Project > New
with Wizard
Then click button: ”Find drive units online”.
Compile
drive units offline...
STARTER Project Wizard
Find drive units
online...
Open existing project
(offline)...
Display Wizard at start–up
Cancel
Introduction
1.
Create a
new project
2.
Set PG/PC
interface
3.
Insert
drive
device
4.
Summary
2. Enter the desired project data. You can enter any of the data.
Then click button: ”Next>”
Please enter the desired project data:
STARTER Project Wizard
Project name:
Author:
Comment
Continue >
Introduction
1.
Create a
new project
2.
Set PG/PC
interface
3.
Insert
drive
device
4.
Summary
Cancel
< Back
Project|
3. Set the PG/PC interface if required and test whether all SINAMICS drive
units connected to the PROFIBUS which are to be commissioned as part of
this project are accessible via the PG/PC interface. To proceed to the next
dialog box click the button: ”Change and test...”.
Execution
9 Drive Commissionin
g
(
SINAMICS
)