Siemens Sinumerik 840DiE sl - Control Unit: Error Acknowledgement (BICO Interconnection)

01/2007
9.2 ONLINE commissioning
9-256
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) -- 01/2007 Edition
9.2.8 Control Unit: Error acknowledgement (BICO interconnection)
To acknowledge an error for the Control Unit, use the ”PROFIBUS PDA1
received” signal from the first drive.
S Control Unit: p2103 BI: 1. Acknowledge faults
S Drive: Drive_1, r2090: Bit7, BO: PROFIBUS PZD1 receive bit--serial
Perform the following actions:
1. Double--click Project > Drive_Unit_Addr10 > Control Unit > Control Logic to
open control logic configuration in the project navigator..
2. Click the binector input symbol of signal ”p2103 BI: 1. Acknowledge faults”
and from the list select Drive_1 > Further interconnections > r2090: Bit7, BO:
PROFIBUS PZD1 receive bit--serial
Drive_01, r2090: Bit7, BO: PROFIB
p2103 BI: 1. Acknowledge faults
Control Logic
Control word, faults/alarms
Optimize view
p2104 BI: 2. Acknowledge faults
p2105 BI: 3. Acknowledge faults
p2112 BI: E xternal alarm 1
r2139 Bit 0 Ac knowledgement running
r2139 Bit 6 Internal Message 1 acti ve
0
0
1
-- --
r2139 Bit 7 Al arm activ e
-- --
Status word, faults/alarms 1
Control_Unit
7
6
0
10
HelpClose
p2103 BI: 1. Acknowledge faults
is interconnec ted with...
Drive_1, r2090: Bit7, BO: P ROFIBUS PDA 1 receive bit--serial: : Bit 7 (0=Out/1=In)
Execution
9
D
r
i
v
eComm
i
s
s
i
on
i
n
g
(
SI
N
A
MICS
)