Siemens Sinumerik 840DiE sl - Page 276

01/2007
10.1 SIMODRIVE 611 universal/E, POSMO CD/CA and SI
10-276
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
3. SimoCom U is installed on the SINUMERIK 840Di sl and is routed from
the PLC to the PROFIBUS. Via the PROFIBUS DP interface of the MCI
board, SimoCom U is connected to all drives using a PROFIBUS cable.
Within the framework of SINUMERIK 840Di sl, the procedure described above
(Point 3.) is recommended:
The advantages of this procedure are:
S SimoCom U is always available for:
– commissioning
– diagnosis
– controller optimization
– software upgrade of drive firmware
– software upgrade of option module firmware
S No additional PG/PC required
S No additional cables required
Recommended
procedure
10 Drive Commissionin
g
(
SIMODRIVE
)