Siemens Sinumerik 840DiE sl - Starting Online Operation

01/2007
10.1 SIMODRIVE 611 universal/E, POSMO CD/CA and SI
10-282
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
S Open the hardware configuration of the station (double–click with left mouse
button on: Hardware; ”HW Config” will be started)
S Open DP master (in the example project: DP master) (double–click with left
mouse button on DP master)
S You will find the subnet ID as follows using the Properties dialog box of the
DP master:
Dialog box: Properties – DP Master
Tab card: General
Group box: Interface
Type: PROFIBUS
Address: 2
Button: ”Properties...”
Dialog box: Properties – PROFIBUS DP Master interface
Tab card: Parameter
Subnet: PROFIBUS
Button: ”Properties...”
Dialog box: Properties PROFIBUS
Tab card: General
S7 subnet ID:
0010 0005
–
(Example)
Cancel
Cancel
Cancel
The online operation with the drives connected to PROFIBUS can now be
started.
10.1.7 Starting online operation
After parameterization of the MPI interface and entry of the routing information,
SimoCom U can enter online operation with the SIMODRIVE drives.
To start the search for any drives connected,
– quit the above dialog box for setting the MPI interface with button:
”Go online”
or
– use menu command Commission > Search for online drives
The SIMODRIVE drives with which SimoCom U could start the online operation
are displayed in the SimoCom U main screen:
– Drive and dialog browser (left window)
– Status overview (upper status bar)
Dialog box
Start search
Display of the
drives
10 Drive Commissionin
g
(
SIMODRIVE
)