Siemens Sinumerik 840DiE sl - Installing Simocom U

01/2007
10.2 Installing SimoCom U
10-283
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
10.2 Installing SimoCom U
SimoCom U is part of the 611U toolbox supplied with the SINUMERIK 840Di sl.
S Installation directory: See Section 1.2, Page 1-33ff
Engineering Tools > SIMODRIVE 611 Universal Toolbox > SimoCom U
To install SimoCom U, start file setup.exe and follow the further installation
instructions.
Note
Before you install SimoCom U please consult the relevant notes in the
readme.txt file in the installation directory.
SimoCom U provides the following functions:
– Make an online connection to the drives
– Upgrade the firmware
– Optimize the control parameters
– Traversing the axes
– Diagnose the drive status
After installation, the documentation for SimoCom U is available electronically.
Use the menu command Help in SimoCom U to call information on the topics:
– Short introduction...
– How to Use WINDOWS Help...
– Help Topics...
– Key Operation...
– Wiring...
– About SimoCom U...
You will also find a detailed description about SimoCom U in:
/FBU/ SIMODRIVE 611 universal Description of Functions
J
Installation
Scope of functions
Online help
References
10 Drive Commissionin
g
(
SIMODRIVE
)