01/2007
11.2 Machine and setting data
11-287
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
A concise table of all machine and setting data is to be found in:
References: /LIS/ Lists
Machine and Setting Data
Note
To search for information regarding machine and setting data, it is
recommended to use the search functions in the electronic documentation:
SINUMERIK DOConCD.
11.2.1 Display and input
To display and input machine data, appropriate screen forms are provided.
The screen forms are found on the HMI Advanced user interface at:
Area Switchover –> Commissioning –> Machine Data.
Notice
To input machine data, at least the password of protection level 2 (default:
”EVENING”) must be set.
To facilitate the input of machine data in the bit format (HEX), a bit editor is pro-
vided.
If the input cursor is on a machine data in HEX format in the MD list, you can
call up the editor by pressing the toggle key (in the middle of the cursor keys).
Fig. 11-1 Input screen form of the bit editor for HEX machine data
Machine data
screen forms
Bit editor
11 NCK Commissionin
with HMI Advanced
To Next Page
Loading...
