Siemens Sinumerik 840DiE sl - Page 289

01/2007
11.2 Machine and setting data
11-289
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
For the four possible password levels with their access permissions, the pass-
words can be entered in the control area DIAGNOSIS by actuating the softkey
SET PASSWORD.
References: /BA/ Operator’s Guide
Please note that a password remains valid until access authorization is reset with the
softkey DELETE PASSWORD.
Access authorization is therefore not automatically deleted during POWER ON!
Up to eight characters are possible for a password. We recommend that you
restrict yourself to the character set of the operator panel in selecting a pass-
word. Where a password consists of less than eight characters, the additional
characters are interpreted as blanks.
The following default passwords have been set for protection levels 1 to 3:
– Protection level 1: SUNRISE
– Protection level 2: EVENING
– Protection level 3: CUSTOMER
Notice
A system power–up with loading the default machine data (after ”Delete NCK
data”, e.g. using 840Di Start–up) will reset the passwords to the default values.
These passwords should be changed to ensure effective access protection.
The protection levels of machine and/or setting data can be modified both with
respect to complete machine or setting data ranges and for single data.
Data areas
Table 11-4 Protection levels: Machine data
Number
Identifier Name Refer-
ence
MMC machine data ($MM_.... )
9200 USER_CLASS_READ_TOA Read tool offsets
9201 USER_CLASS_WRITE_TOA_GEO Write tool geometry
9202 USER_CLASS_WRITE_TOA_WEAR Write tool wear data
9203 USER_CLASS_WRITE_FINE Write Fine
9204 USER_CLASS_WRITE_TOA_SC Change additive tool offsets
9205 USER_CLASS_WRITE_TOA_EC Change tool setup offsets
9206 USER_CLASS_WRITE_TOA_SUPVIS Change tool monitoring limit values
9207 USER_CLASS_WRITE_TOA_ASSDNO Change D No. assigned to a tool edge
9208 USER_CLASS_WRITE_MAG_WGROUP change wear group magazine location/mag.
9209 USER_CLASS_WRITE_TOA_ADAPT Tool adapter data
9210 USER_CLASS_WRITE_ZOA Write settable zero offset
9213 USER_CLASS_OVERSTORE_HIGH Extended overstore
9214 USER_CLASS_WRITE_PRG_CONDIT Program control
Setting the
password
Resetting
the password
Possible
characters
Default
passwords
Redefining
protection levels
11 NCK Commissionin
g
with HMI Advanced