Siemens Sinumerik 840DiE sl - Axis Names

01/2007
11.5 Axes and spindles
11-313
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Table 11-15 Axis configuration: Machine data
Number
Identifier Name/remarks Refer-
ence
General ($MN_ ... )
13050 DRIVE_LOGIC_ADDRESS I/O address of drive
Channel–specific ($MC_ ... )
20050 AXCONF_GEOAX_ASSIGN_TAB Assignment of geometry axis to channel axis
20070 AXCONF_MACHAX_USED Machine axis number valid in channel
Axis–specific ($MA_ ... )
30110 CTRLOUT_MODULE_NR Setpoint assignment
30220 ENC_MODULE_NR Actual–value assignment
/FB/ Description of Functions, Basic Functions,
K2 Axes, Coordinate Systems, Frames, Workpiece Actual–Value System,
Chapter: Axes
11.5.2 Axis names
Each machine, channel and geometry axis can/must be assigned an individual
name unambiguously identifying it in its name range.
Machine data
S MD10000: AXCONF_MACHAX_NAME_TAB [n] (machine axis name)
is used to define the machine axis names.
Machine axis names must be unambiguous for the entire NCK.
The names and the corresponding index defined in the machine data above is
used for
S Accessing axis–specific machine data (loading, saving, displaying)
S Reference point approach from the part program G74
S Measurement
S Test point traversing from the part program G75
S Traversing the machine axis from PLC
S Display of axis–specific alarms
S Display in the actual–value system (machine–related)
S DRF handwheel function
Machine data
S MD20080: AXCONF_CHANAX_NAME_TAB[n] (name of the channel axis in
the channel)
is used to define the channel axis names. Channel axis names must be unam-
biguous for the entire channel.
Machine data
References
Machine axes
Channel axes
11 NCK Commissionin
g
with HMI Advanced