Siemens Sinumerik 840DiE sl - Page 385

01/2007
11.6 Handwheels
11-385
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
PROFIBUS module
Slot
Machine control panel MCP 438 2
Machine control panel MCP 310 2
Handwheel connection module 1
Parameterization of 5 handwheels, connected via 4 machine control tables
”MCP 483”. Two handwheels can be connected to a machine control table
”MCP 483”.
Handwheel
number in NCK
Machine data set
(Index)
Terminal
1 0 1st MCP, 1st handwheel in handwheel
slot
2 1 1st MCP, 2nd handwheel in handwheel
slot
3 2 2nd MCP, 1st handwheel in handwheel
slot
5 4 3rd MCP, 1st handwheel in handwheel
slot
6 5 4th MCP, 2nd handwheel in handwheel
slot
The fourth handwheel in NCK has not been used (gap in machine data).
Note
Machine data gaps are allowed when parameterizing handwheels in NCK
machine data.
Machine control tables have been configured in SIMATIC STEP 7, HW Config
as follows:
Table 11-50 Configuration
Slot DP ID Order number/
designation
I address O address
1st MCP 1 55 Standard+Handwheel 0 ... 7 0 ... 7
2 2AE –> Standard+Handwheel 288 ... 291
3 1 –> Standard+Handwheel
2nd MCP 1 55 Standard+Handwheel 8 ... 15 8 ... 15
2 2AE –> Standard+Handwheel 304 ... 307
3 1 –> Standard+Handwheel
3rd MCP 1 55 Standard+Handwheel 16 ... 23 16 ... 23
2 2AE –> Standard+Handwheel 3320 ... 323
3 1 –> Standard+Handwheel
4th MCP 1 55 Standard+Handwheel 24 ... 29 24 ... 29
2 2AE –> Standard+Handwheel 330 ... 333
3 1 –> Standard+Handwheel
Example
11 NCK Commissionin
g
with HMI Advanced