Siemens Sinumerik 840DiE sl - Page 388

01/2007
11.6 Handwheels
11-388
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Call parameter of the function module FB1 in organization module OB100:
Parameter Value Comment
MCPNum := 1 // MCP available
MCP1In := P#E0.0 // Address of the input data
MCP1Out := P#A0.0 // Address of the output data
MCP1StatSend := P#A8.0 // Address of the send status data
MCP1StatRec := P#A12.0 // Address of the receive status data
MCP1BusAdr := 192 // ”Address” set via switch S2
// on the MCP
MCPBusType := b#16#55 // Bus type: Ethernet
11 NCK Commissionin
g
with HMI Advanced