01/2007
11.10Initial settings
11-405
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
11.10 Initial settings
The status of an NCK function, e.g. G codes, tool length compensation, trans-
formation, coupled motion, etc., which is taken in a certain status of a channel is
a default setting.
Channel states for which default settings can be parameterized are:
1. Power up (NCK reset), reset (channel or mode group reset) and end of part
program
and
2. Part program start
The default setting of an NCK function remains stored until it is explicitly
changed by operation or programming.
The machine data:
S MD20110: RESET_MODE_MASK (”Definition of the control default settings
in case of reset”)
S MD20112: START_MODE_MASK (”Definition of the control default settings
in case of NC–Start”)
S MD20150: GCODE_RESET_VALUES (”Reset position of the G groups”)
S MD20152: GCODE_RESET_MODE (”G code initial setting in case of reset”)
are used to define the relevant default settings.
Table 11-57 Default settings that can be parameterized through MD
State
parameterizable through MD
Power up (POWER ON) MD20110: RESET_MODE_MASK
MD20150: GCODE_RESET_VALUES
RESET/part program end MD20110: RESET_MODE_MASK
MD20150: GCODE_RESET_VALUES
MD20152: GCODE_RESET_MODE
Part program start MD20112: START_MODE_MASK
MD20110: RESET_MODE_MASK
/FB1/ Description of Functions, Basic Functions,
K2 Axes, Coordinate System, Frames, Workpiece Actual–Value System
Chapter: Workpiece–related actual value system/reset response
Concept
Initial settings
parameter
assignment
References
11 NCK Commissionin
with HMI Advanced
To Next Page
Loading...
