Siemens Sinumerik 840DiE sl - Spindle Dry Run

01/2007
13.3 Spindle dry run
13-424
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
13.3 Spindle dry run
– Check the enables on the drive
– Check the interface signals
– Check the machine and setting data
MD32250 Rated output voltage
1)
MD32260 Rated output speed
MD 35100–35150 Spindle speed limitation
MD 36200 AX_VELO_LIMIT
SD 41200 JOG_SPIND_SET_VELO
SD 43220 SPIND_MAX_VELO_G26
SD 43210 SPIND_MIN_VELO_G25
– Service display
Enable spindle
(controller enable NC,
enable on drive)
Does the
spindle
rotate?
Is
traversing
direction
okay?
Yes
No
No
Specify spindle speed
Specified speed 100 rev/min
Actual
speed
=
Set
speed?
No
Yes
Yes
Check:
MD32100: AX_MOTION_DIR
Check:
MD31000 – 31080: (encoder matching)
1) Speed setpoint matching
– ADI4: MD32250 0
– SINAMICS S120: MD32250 = 0
– SIMODRIVE 611 universal/E; POSMO CD/CA, SI: MD32250 = 0
IS
”Spindle in
setpoint range”
(DB31–DBxx,
DBX83.5)?
No
Yes
All gear
stages
tested?
No
Yes
1
Change over
gear stage
Check machine data
MD 35110–35140Speeds for gear stages
MD 35150 Spindle speed tolerance
Check interface signals (DB31, ...)
DBB16 Actual gear stage
DBB21 Select drive parameter set
DBB8 Set gear stage
DBB93 Active drive parameter set
13 Axis and S
p
indle Test Run