01/2007
14.6 Trace function
14-446
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
To select the axis/spindle, position the cursor on the appropriate ”Axis/spindle
name” list field.
You can also select the axis/spindle directly in the list box from the dropdown list
using the cursor.
With the Start softkey, trace function recording is started.
With the Stop or RESET softkey, you can cancel a running measurement.
Within the framework of the trace function, it is also possible to select data using
its physical address.
Fig. 14-9 Menu: Physical address for trace x
To do so, proceed as follows:
– Choose the signal type Physical address from the desired trace.
– Press the softkey Physical address.
– Enter the desired values in the input screen form.
– Press the softkeys OK to complete your input.
Notice
This function is only required in exceptional cases, for example, if the
information provided by the known signals (see Signal selection list field) is
not adequate.
Before using this function, you should contact the SINUMERIK hotline.
The input of all parameters is carried out in the hexadecimal number format.
This screen form is used to select the data format to be evaluated when recording.
– Byte: 0000 00FF
– Word: 0000 FFFF
– Double word: FFFF FFFF
Softkey:
Axis +
Axis –
Softkey:
Start
Stop
Softkey:
Physical
address
Input field:
Screen form
14 Drive O
timization with HMI Advanced
To Next Page
Loading...
