Siemens Sinumerik 840DiE sl - Creating a Series Commissioning File

01/2007
15.2 Creating a series commissioning file
15-460
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
15.2 Creating a series commissioning file
15.2.1 General
Note
Because of its file extension ”.arc”, the series startup file is also called archive.
The following components can be selected as the content of a series commis-
sioning file:
S NCK with/without compensation data (see below: Note)
S PLC
S HMI
S SIMODRIVE PROFIBUS drives
When selecting, any combinations are possible. However, it is recommended to
save the individual components separately in separate series startup files. It is
thus possible to reload them independently of each other and with maximum
flexibility.
Note
Machine–specific compensation data only needs to be archived if the series
startup file is to be reloaded into the same control system (backup).
The contents of a series startup file created for the NCK comprises mainly the
following data:
– Machine data
– Setting data
– Option data
– Global (GUD) and local (LUD) user data
– Tool and magazine data
– Protection zone data
– Arithmetic variables
– Work offsets
– Compensation data
– Display machine data
– Workpieces, global part programs and subroutines
– Standard and user cycles
– Definitions and macros
Archive content
NCK
15 User Data Backu
p
/Standard Commissionin
g