Siemens Sinumerik 840DiE sl - Installation of the SINUMERIK 840 Di Sl Applications

01/2007
16.4 Restoring the as–delivered state
16-475
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
16.4.3 Installation of the SINUMERIK 840Di sl applications
The installation programs for the SINUMERIK 840Di sl applications saved on
D:\INSTALL are not executed automatically after partition restoration, as was
the case during the initial boot. To do this manually in the correct sequence,
proceed as follows:
1. On next PCU start–up after restoration of the partitions, you are prompted to
enter the password for the SINUMERIK desktop.
Start the Windows Explorer on the SINUMERIK desktop and open the direc-
tory:
S D:\SETUP\APPS
The subdirectories contained in directory APPS contain:
– \001 Installation directories of the 1st application
– \002 Installation directories of the 2nd application
– . . . .
– \xxx Installation directories of the xxxth application
The numbers in the directory name indicate order in which the applications
have to be installed.
2. Next open directory:
S D:\SETUP\APPS\001
The subdirectories contained in directory \001 contain:
– \000 Installation directories of the application
– \001 – \xxx Installation directories of options, patches,
etc.
The numbers in the directory name indicate order in which the installation
programs have to be run.
3. Next open directory:
S D:\SETUP\APPS\001\000
and start the installation program in the directory (SETUP.EXE).
Then following the installation instructions shown.
Notice
If you are prompted to reboot during installation, always confirm this with ”Yes”
and reboot.
4. Proceed with all (existing) directories
S D:\SETUP\APPS\001\001 to \xxx
as described in item 3.
16 Software Installation/U
p
date and Data Backu
p