Siemens Sinumerik 840DiE sl - How to Refresh the Navigation View: Manage

01/2007
17.3 Assigning via Automation License Manager
17-493
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
17.3.5 How to refresh the navigation view: ”Manage”
After actions which add or remove elements in the navigation area of the navi-
gation view: ”Manage” of the Automation License Manager (e.g. deletion of a
control image (offline), enabling/disabling of plug–ins), the view is normally re-
freshed automatically. If the view does not refresh automatically after an oper-
ation, you can refresh the view manually.
Perform the following actions to manually refresh the navigation view: ”Manage”
manually:
1. Select the following nodes in the navigation area of the Automation License
Manager: My Computer
2. Refresh the view using one of the following options:
– Menu command: View > Refresh
– Key F5
– Toolbar:
The navigation view of the Automation License Manager is refreshed: All sub–
nodes under the node: My Computer are closed.
The object view of the Automation License Manager shows the current nodes
and drives of the navigation area.
17.3.6 Displaying the license information of a piece of hardware
To perform one of the following tasks with the Automation License Manager:
S Check the license information for the hardware
S Ascertain the license requirement for the hardware and align if necessary
S Assign new licenses to hardware and transfer updated license information
including License Keys to the hardware
you must display the license information for a piece of hardware.
The license information can only be displayed if the Automation License Man-
ager is communicating with the relevant SINUMERIK control system. A descrip-
tion of how to assign parameters for TCP/IP communication with a control
system is given in Section 17.3.4, Page 17-490.
Background
Execution
Result
Background
Requirements
17 License Mana
g
ement