Siemens SINUMERIK ONE MCP 2400.4c Equipment Manual

6\VWHPQHWZRUN
6ZLWFK
6,180(5,.'VO
3&8237237237
Figure4-22 Con󹪝guration example
Proceed as follows
To con󹪝gure the application example, proceed as follows:
1. PCU50.3 with HMI Advanced
Deactivate the DHCP server on the PCU: For this select the option "Boot support runtime and
con󹪝guration only (TFTP/FTP)" on the "TCU support" tab of the "System Network Center"
program.
2. SINUMERIK 840D sl from CNC software, version 2.4 and higher
The systemconfiguration.ini con󹪝guration 󹪝le is included on the SINUMERIK 840D
sl product DVD.
3. OP08T operator panel
Once the installation of the OP08T operator panel with SINUMERIK Operate has been
completed, copy the systemconfiguration.ini 󹪝le from the /Siemens/
sinumerik/hmi/appl/systemconfig/tm/ directory to the /oem/
sinumerik/hmi/cfg/ directory. After this, a system restart is necessary.
Note
Subsequent changes
Once the 󹪝le has been copied, no further settings (e.g. changing language)can be
implemented on the SINUMERIK Operate. If you want or need to implement changes later,
the systemcon󹪝guration.ini 󹪝le can be renamed (e.g., as systemcon󹪝guration.save). After
this, a system restart is necessary. Following the restart, the full functional scope of
SINUMERIK Operate is available once again.
General information and networking
4.3Networking
Handheld Terminal HT 8
86 Equipment Manual, 02/2024, A5E52918633B AA

Siemens SINUMERIK ONE MCP 2400.4c Specifications

General

Brand	Siemens
Model	SINUMERIK ONE MCP 2400.4c
Category	Control Systems
Language	English