Siemens SIPROTEC 7SJ531 - Page 44

4ECHNICAL DATA3*
6
#
' #

 !UTO RECLOSURE OPTIONAL
-AX NUMBER OF POSSIBLE SHOTS  2!2 FIRST SHOT
UP TO  $!2 FURTHER SHOTS
!UTO
RECLOSE MODES THREE POLE
!CTION TIMES  S TO  S STEPS  S
OR 0
2!2 DEAD TIME SEPARATE SINGLE
PHASEMULTI PHASE  S TO  S STEPS  S
$!2 DEAD TIMES SEPARATE SINGLE
PHASEMULTI PHASE  S TO  S STEPS  S
2ECLAIM TIME  S TO  S STEPS  S
,OCK
OUT TIME  S TO  S STEPS  S
OR 0
$URATION OF 2%#,/3% COMMAND  S TO  S STEPS  S
BREAKER SUPERVISION TIME  S TO  S STEPS  S
 &AULT LOCATION


/UTPUT OF FAULT DISTANCE IN ¬ SECONDARY
IN KM OR IN MILES LINE LENGTH

3TART TO MEASURE COMMAND BY TRIP SIGNAL OR BY DROP OFF OF FAULT DETECTION
OR BY EXTERNAL COMMAND VIA BINARY INPUT
3ETTING REACTANCE PER UNIT LINE LENGTH SECONDARY  ¬MILE TO  ¬MILE
STEPS  ¬MILE OR
 ¬KM TO  ¬KM
STEPS  ¬KM
-EASURING TOLERANCES ACCORDING 6$%  PART     OF LINE LENGTH WITHOUT INTERMEDIATE
SINUSOIDAL QUANTITIES INFEED
FOR 
 
SC
  AND 5
SC
5
.
 

 3ECONDARY VALUES ARE RELATED ON )
.
!FOR)
.
  ! THE VALUES ARE TO BE DIVIDED BY 

 /UTPUT OF FAULT DISTANCE IN KM OR MILES ONLY FOR HOMOGENEOUS LINES

 ONLY FOR MODEL 3* J JJJJ JJJJ
www . ElectricalPartManuals . com