Data in the PROFIBUS-DP messages
7SJ61...7SJ63, 7SJ65, 6MD63 PROFIBUS-DP – Bus mapping
C53000-L1840-B006-02
1-14
1.6 Using device firmware version 4.3 or higher
The following SIPROTEC objects are no longer included per default in
the parameter set of the device.
Double commands:
• Switching device D1 (UsrDC1) ...
Switching device D3 (UsrDC3)
Single commands:
• Output channel E1 (UsrSC5) ...
Output channel E6 (UsrSC12)
Application logic CFC:
• CFC-Incoming annunciation 1 (UsCfcSpI1) ...
CFC-Incoming annunciation 16 (UsCfcSpI16)
• CFC-Output indication 1 (UsCfcSpO1) ...
CFC-Output indication 16 (UsCfcSpO16)
Input channels with allocation to the binary inputs and tagging:
• Input channel 1 (UsrSpO/C1) ...
Input channel 8 (UsrSpO/C32)
After creating a SIPROTEC device with device firmware version 4.3 or
higher in the parametrization system DIGSI and assignment of a
PROFIBUS-DP mapping the PROFIBUS-DP message positions at
which the above-mentioned SIPROTEC objects are defined in according
to the descriptions (ref. to chap. 2 to 5) contain no pre-allocation.
Additional protection alarms or user defined annunciations can be routed
on these positions using DIGSI Configuration matrix.
To Next Page
Loading...
