Siemens SIPROTEC4 7SJ61 - Page 8

Table of contents
7SJ61...7SJ63, 7SJ65, 6MD63 PROFIBUS-DP – Bus mapping
C53000-L1840-B006-02
vi
2.2.1.5 Diagnosis.....................................................................................................................2-5
2.2.1.6 Automatic recloser status............................................................................................2-6
2.2.1.7 Time overcurrent protection.........................................................................................2-6
2.2.1.8 Directional time overcurrent protection........................................................................2-7
2.2.1.9 Unbalanced load protection.........................................................................................2-7
2.2.1.10 Frequency protection ..................................................................................................2-7
2.2.1.11 Undervoltage and overvoltage protection ...................................................................2-8
2.2.1.12 Sensitive ground fault protection.................................................................................2-8
2.2.1.13 Circuit breaker failure protection .................................................................................2-8
2.2.1.14 Thermal overload protection .......................................................................................2-9
2.2.1.15 Motor start protection ..................................................................................................2-9
2.2.1.16 Startup supervision .....................................................................................................2-9
2.2.1.17 Trip coil monitor...........................................................................................................2-9
2.2.1.18 Cold load pickup setup................................................................................................2-9
2.2.1.19 Measurement supervision.........................................................................................2-10
2.2.1.20 Set point alarms ........................................................................................................2-10
2.2.1.21 Status annunciations.................................................................................................2-10
2.2.2 Measured values.......................................................................................... 2-11
2.2.2.1 Recorded measured values.......................................................................................2-11
2.2.2.2 Measured values – mean values...............................................................................2-11
2.2.3 Fault locator.................................................................................................. 2-12
2.2.4 Metered measurands ................................................................................... 2-12
3 Standard mapping 2-2 ................................................................................................... 3-1
3.1 Message in output direction ........................................................................... 3-1
3.1.1 Double commands (with checkback indication)............................................. 3-1
3.1.2 Single commands (without checkback indication) ......................................... 3-1
3.1.3 Internal commands......................................................................................... 3-2
3.1.4 Application logic CFC..................................................................................... 3-2
3.2 Message in input direction.............................................................................. 3-4
3.2.1 Annunciations................................................................................................. 3-4
3.2.1.1 Double commands – checkback signals .....................................................................3-4
3.2.1.2 Single commands – status ..........................................................................................3-4
3.2.1.3 Input channels with allocation to the binary inputs and tagging ..................................3-4
3.2.1.4 Application logic CFC..................................................................................................3-5
3.2.1.5 Diagnosis.....................................................................................................................3-5
3.2.1.6 Automatic recloser status............................................................................................3-6
3.2.1.7 Time overcurrent protection.........................................................................................3-6
3.2.1.8 Unbalanced load protection.........................................................................................3-7
3.2.1.9 Sensitive ground fault protection.................................................................................3-7
3.2.1.10 Circuit breaker failure protection .................................................................................3-7
3.2.1.11 Thermal overload protection .......................................................................................3-7
3.2.1.12 Motor start protection ..................................................................................................3-7
3.2.1.13 Startup supervision .....................................................................................................3-7
3.2.1.14 Trip coil monitor...........................................................................................................3-8