Siemens SIPROTEC4 7SJ65 - Default Chapter; Table of Contents

7SJ61...7SJ63, 7SJ65, 6MD63 PROFIBUS-DP – Bus mapping
C53000-L1840-B006-02
v
Table of contents
1 Data in the PROFIBUS-DP messages........................................................................... 1-1
1.1 Explanation..................................................................................................... 1-1
1.2 Messages in output direction: PROFIBUS-DP master to the SIPROTEC
device............................................................................................................. 1-3
1.3 Messages in input direction: SIPROTEC device to the PROFIBUS-DP
master ............................................................................................................ 1-3
1.3.1 Annunciations................................................................................................. 1-3
1.3.2 Measured values............................................................................................ 1-4
1.3.3 Metered measurands ..................................................................................... 1-5
1.4 Configuration data of the standard mappings 2-1 to 2-4................................ 1-6
1.5 Notes to SIPROTEC objects........................................................................ 1-10
1.5.1 Single commands......................................................................................... 1-10
1.5.2 Control mode REMOTE ............................................................................... 1-11
1.5.3 Changing the setting group.......................................................................... 1-11
1.5.4 CFC-Incoming annunciations....................................................................... 1-12
1.5.5 Error with a summary alarm......................................................................... 1-12
1.5.6 Alarm summary event.................................................................................. 1-13
1.5.7 Stop data transmission................................................................................. 1-13
1.5.8 Fault locator: Fault location .......................................................................... 1-13
1.6 Using device firmware version 4.3 or higher................................................ 1-14
2 Standard mapping 2-1 ................................................................................................... 2-1
2.1 Message in output direction ........................................................................... 2-1
2.1.1 Double commands (with checkback indication)............................................. 2-1
2.1.2 Single commands (without checkback indication) ......................................... 2-1
2.1.3 Internal commands ........................................................................................ 2-2
2.1.4 Application logic CFC..................................................................................... 2-2
2.2 Message in input direction ............................................................................. 2-4
2.2.1 Annunciations................................................................................................. 2-4
2.2.1.1 Double commands – checkback signals.....................................................................2-4
2.2.1.2 Single commands – status..........................................................................................2-4
2.2.1.3 Input channels with allocation to the binary inputs and tagging..................................2-4
2.2.1.4 Application logic CFC..................................................................................................2-5