SIREMOBIL Compact Register 5 RXR2-130.061.02 Page 14 of 18 Siemens AG
System Manual Rev. 03 10.03 CS PS 24 Medical Engineering
6 - 14 Replacing boards / replacing components
Memoskop C-E 6
• Replace the Memoskop C-E.
The attachment screws are on the underside of the storage device.
• Configure the Memoskop C-E for the correct video frequency and the number of
monitors present.
Refer to Chapter 5 "Memoskop C-E without Keyboard, Emulation ...", "Configuring the
Video frequency" and "MEMOSKOP-Configuration for the number of existing monitors".
• Configure the following parameters in Technical Setup for the Memoskop:
• Configure the following parameters in User setup for Memoskop:
Read and record the parameters for Memoskop C-E if you are able
to select User setup. After replacing the Memoskop, configure the
Memoskop C-E according to the parameters noted.
3 Number of monitors Configure 1 for SIREMOBIL Compact with1 monitor.
Configure 2 for SIREMOBIL Compact with 2 monitors.
4 Hardcopy setup Check whether 5500 is programmed in "4 Max Hardcopy
time". If not, program this value.
5 Edge 1 coef set Check whether 3 is programmed, if not, program this value.
6 Edge 2 coef set Check whether 8 is programmed, If not, program this value.
7 Motion detection setup Check whether the following are programmed MD1: Thresh-
old 100 and at MD2: Threshold 120.
If not, program these values.
10 Date / Time format Set to country-specific format.
12 Keyboard Set to the keyboard layout being used.
13 Language Set for the language of the country.
15 Display of realtime clock Configure Yes. Configure No only upon customer request.
16 Display of rotated images Configure Yes.
17 Monitor zoom Configure No.
18 Monitor split Configure Yes for SIREMOBIL Compact with 1 monitor.
Configure No for SIREMOBIL Compact with 2 monitors.
19 Monitor text Configure Yes.
20 Maximum image number Configure 100.
A Operating mode parameters Change the programmed parameters only on the cus-
tomer’s request.
B Video recorder output Configure to Monitor A.
C Documentation For SIREMOBIL Compact with 1 monitor:
Configure to monitor A.
For SIREMOBIL Compact with 2 monitors:
Configure to monitor B.
D Text monitor For SIREMOBIL Compact with 1 monitor:
Configure to monitor A.
For SIREMOBIL Compact with 2 monitors:
Configure to both monitors.
NOTE
To Next Page
Loading...
