Siemens SIREMOBIL - Wiring of the Displays; Running the Cables

Installation of TFT displays 2 - 7
Siemens AG SPR2-230.812.02 Page 7 of 8 SIREMOBIL
Medical Solutions Rev. 02 02.06 CS PS SP System Manual
Wiring of the displays 2
• Open the rear panel of both TFT displays above the connections.
• Route the power line cables and the video cables to the TFT displays.
BARCO displays 2
• Connect the video cable to the BNC sockets VIDEO of the displays and lock it.
• Connect the shieldings of the video cables to the ground of the display.
• Plug in the power cables.
• Close both covers again located above the display connections.
Running the cables 2
• If required, retract the power line cables and video cables into the monitor trolley.
- Route the cables without sharp bending radius.
- It is recommended to ensure that the cables are covered by both support arm rails in
the area between support arm base and the displays (see Fig. 11).
- The cables should rest in the cable bushes of the support arm base without excessive
pulling force or stress (Fig. 15).
• Reattach the cover of the support arm (Fig. 15).
• When present, switch on the power switches of the TFT displays.
Fig. 15 Cover of the support arm
Mark for the keyboard tray