Accessories
9.26 Assembly kit for reversing contactor assemblies (sizes S00 to S3)
SIRIUS - SIRIUS 3RT Contactors/Contactor assemblies
Manual, 09/2017, A5E03656507120A/RS-AE/006
373
Assembling the reversing contactor assembly with spring-loaded connection - size S0
The illustrations below show the components of the assembly kit for the reversing contactor
assembly in size S0 and explain the assembly procedure. The mechanical interlock and the
connecting clips are mounted in the same way as described for size S00 with screw-type
connection. See the chapter "Mounting S00 (Page 368)" in this regard.
Attach the wiring modules for connecting the main current paths to the contactors from above.
Attach the wiring modules for connecting the main current paths to the contactors from below.
To connect the control current paths, strip the conductors and push them into the contactor
terminals.
Note:
The conductors required for connecting the control current paths are not included in the scope
of supply of the assembly kit for reversing contactor assemblies with spring-loaded connection
To Next Page
Loading...
