Siemens SIRIUS 3RW44 - Page 137

General Technical Data
SIRIUS 3RW44 manual
GWA 4NEB 535 2195-02 DS 02
9-13
1) Parameter motor left possible only in conjunction with creep mode.
Type 3RW44 ..
Factory presetting
Control times and parameters
Warnings/error signals (contd.)
Temperature sensor
• Overload
• Open-circuit
• Short-circuit
Ground fault
•Detected
• Shutdown
Connection abort in manual mode
Max. number of starts exceeded
I
e
limit value overshoot/undershoot
Cooling time
• Motor active
• Switch block active
Heat sink sensor
• Open-circuit
• Short-circuit
Quick-stop function
Switch block faulty
I
e
/class setting not permissible
Control inputs
Input 1 Motor right parameter set 1
Input 2
No action
Input 3
No action
Input 4
Trip reset
Parameterizing options for control inputs 1 ... 4
No action
Local manual mode
Emergency start
Creep speed
Quick-stop
Trip reset
Motor right parameter set 1
Motor left parameter set 1
1)
Motor right parameter set 2
Motor left parameter set 2
1)
Motor right parameter set 3
Motor left parameter set 3
1)
Relay outputs
Output 1 ON period
Output 2
No action
Output 3
No action
Output 4
Group error
Parameterizing options for relay outputs 1 ... 3
No action
PAA output 1
PAA output 2
Input 1
Input 2
Input 3
Input 4
Soft starting
Operation/Bypass
Ramp-down
ON period
Command motor on
Fan
DC braking contactor
Group warning
Group error
Bus fault
Device error
Power on
Ready to start
Motor temperature sensor Deactivated Deactivated
Thermoclick
PTC type A